Amtrak Washington train crash: Investigators focus on speed

A US passenger train that derailed, killing three people, was travelling at 80mph (130km/h) on a curve with a speed limit of 30mph, data from the train’s rear engine indicates.

It happened in Washington state during rush hour on Monday and officials say 72 people were taken to hospital.

A number of those injured are reported to be in a serious condition.

Authorities said all carriages had now been searched, but would not rule out a rise in the number of dead.

A spokeswoman for the National Transportation Safety Board (NTSB) said investigators had arrived at the scene on Monday night local time and would probably be there for a week or 10 days.

Bella Dinh-Zarr said the 12-carriage train had engines at the front and rear. The back engine’s data recording had been retrieved, she said, and “preliminary indications are that the train was travelling at 80mph on a 30mph track”.

“Our hearts go out to everyone who is affected by this very tragic accident,” she said.

Warning signs

Passengers say the train rocked and creaked as it took the bend fast before barrelling off a bridge on to a motorway packed with traffic.

Seven vehicles, two of them lorries, were hit on the I-5 highway below. Several people were injured in their vehicles but none died.

State transport spokesperson Barbara LaBoe was quoted in the Seattle Times newspaper as saying the limit on most of the track was 79mph (128km/h) but drivers were supposed to slow dramatically at the spot where the train derailed.

She said warning signs were in place two miles before the lowered limit.

It was Amtrak’s first passenger service to run on a new, shorter route. Amtrak is the name of the company that runs most passenger trains in the US, with some government funding.

The derailment happened on a section of track previously only used for freight trains.

A safety system called Positive Train Control (PTC) was not operational on the train in question, the president of Amtrak told reporters. Using GPS tracking, PTC automatically warns the driver of speed limits and other local conditions and applies the train’s brakes if the warnings are not heeded.

Congress originally legislated for PTC to be installed by the end of 2015 but it is still not even halfway complete.

The cost of implementing the system fully on all tracks and vehicles is reported to be more than $22bn (£16bn).

Train 501 had left Seattle, heading south for Portland, at 06:00 local time (14:00 GMT).

One passenger carriage could be seen dangling from the bridge, while others were strewn across the road and the wooded area next to the track.

There were 86 people on board, including 77 passengers and seven Amtrak crew members, as well as a train technician.

Police say 19 people were taken from the scene uninjured. Of the 72 transferred to hospital for evaluation, 10 were considered to have serious injuries.

Md. Rafiuzzaman Sifat, a CSE graduate turned into journalist, works at News Hour as a staff reporter. He has many years of experience in featured writing in different Bangladeshi newspapers. He is an active blogger, story writer and social network activist. He published a book named 'Se Amar Gopon' inEkushe boi mela Dhaka 2016. Sifat got a BSc. from Ahsanullah University of Science & Technology, Bangladesh. He also works as an Engineer at Bangla Trac Communications Ltd. As an avid traveler and a gourmet food aficionado, he is active in publishing restaurant reviews and cutting-edge articles about culinary culture.
No Comments